

Each of our headstock templates is the precise outline of the headstock on the plan referenced. These templates are laser engraved from 1/8" thick clear acrylic (less brittle than extruded acrylic). This template is designed to be used with a mechanical pencil - specifically, the Graphgear 500 - although others might work. The 0.09mm x 4mm Graphgear sleeve is longer than most mechanical pencils. It is made specifically for templates.
NOTE: this template is virtually identical to the SPTHS3 Parlor template.
12/05/2021
Disappointed
There are no measurements given. I was expecting the width at the bottom of the template to match an OM nut width of 1.75 inches. Sadly, it is 1/16-inch short of that mark. So, as a template, it does not suit my needs.