End pin jack installer, 6" pin
Once again, Frank Ford has come up with a great tool idea. Simply thread your jack fishing tool through the hole you have pre-drilled in your end block and up through your soundhole/f-hole. Snap your pre-wired endpin jack onto the installer pull back through the guitar. Install washers and nuts and tighten. Jack installation couldn't be easier.
Frank designed this tool in 3 configurations so it can be used in almost every type of guitar. The eighteen-inch rod provides easy access from the outside, so you can pull the jack down through the guitar's length to position it in the endpin hole. The short rod is great for pulling jacks up through the face of thinner body instruments, and the flexible rod tool allows you to reach inside more complex areas and is nice for working through f-holes.
- Shipping Restrictions - Location
- No Restrictions
- Tool Type or Function
- Jack Installation