

Richlite® is a versatile composite that was traditionally used as an industrial tooling material. The benefits of using it for fingerboards and bridge blanks are numerous.
IMPORTANT NOTE: Before gluing Richlite up, it’s important that you abrade it with 80-100 grit sandpaper for best adhesion.
Would you like us to radius thickness sand your fingerboard? Choose fingerboard customizations below.
Chrome / Firefox browsers are highly recommended. Internet Explorer is not recommended!
Use the fingerboard calculator in our Help Center to be sure your choices will fit on the board you chose.
If you choose to have your fingerboard slotted, you must make a selection in the remaining fingerboard customizations as well. If you do not make choices, we will choose the following for you: Slot Depth - .095", Nut Slot Position - Standard Nut Slot Position, Nut Slot Offset - 1/8" behind the nut.
To convert mm to inches, divide the mm by a factor of 25.4. Ex: 660mm divided by 25.4 equals 25.98" inches.
Enter the number of fret slots desired. Use the fingerboard calculator to make sure you have chosen a long enough board for the scale and number of frets that you have chosen.
You can't add more than 1 quantities
You must add a minimum of 0 quantities
Choose a radius for your fingerboard. Classical fingerboards are typically not radiused.
Some fingerboard choices cannot be radiused. In this case, no options will appear.
Radiused boards measure 1/4" at the center.
You can't add more than 1 quantities
You must add a minimum of 0 quantities
If you chose to have your fingerboard radiused or don't plan to radius it, choose the shallow slot.
If you plan on radiusing your fretboard later, choose the deep slot.
You can't add more than 1 quantities
You must add a minimum of 0 quantities
We will leave 1/8" behind the nut slot unless you choose the Fender-style option of 1".
You can't add more than 1 quantities
You must add a minimum of 0 quantities
The Standard nut slot moves the kerf back half the width of the slot. Our slots are .024”, so we move it back .012”. This puts the string’s
You can't add more than 1 quantities
You must add a minimum of 0 quantities
We cannot thickness sand radiused boards. Enter a thickness. Expect 5% +/- tolerance. Non-radiused boards measure 5/16". Choose this service if you want us to sand your non-radiused board thinner than 5/16".
You can't add more than 1 quantities
You must add a minimum of 0 quantities
Overview
Total :
Use our Fret Scale and Fingerboard Length Calculator to see if the fingerboard you're ordering is long enough.
The Richlite we offer is produced from 100% post-consumer waste paper pulp – recycled paper mostly from home and office recycling in the mid-west!
No customer reviews for the moment.
Write your review
* Required fields
or Cancel