Honduran Mahogany bolt-on carved concert/tenor ukulele neck
Our bolt-on ukulele neck is a professional quality, precision machined neck made from 1st grade, genuine Mahogany. Often ukes are held on with a simple glued butt joint, but we offer ours with a (single) bolt-on feature, as found on some higher-end ukuleles. Ukuleles don't typically use a truss rod as there is not enough string tension to warrant one.
The neck comes with a hex wrench, bolt, and washer for installation. Depending on the depth of your heel block, you may need to shorten the bolt.
See the drawing above for further specs on this neck.
- Heel depth 1.875"
- Width at the nut 1.350"
- Width at 12th fret 1.75"
- Width at top of peghead 2.35"
- Length of peghead 4.875"
- Thickness of peghead 0.5"
PLEASE NOTE If you order our pre-carved soprano ukulele neck to use in conjunction with the PL51 soprano ukulele plan, be aware of the following: The PL51 plan features a ukulele with 13.5" scale and the pre-carved neck that we offer is a 13.875" scale neck. Therefore, you will need to adjust the placement of your bridge to achieve proper intonation. Be sure that you place the bridge (and bridge plate) according to the 13.875" scale length on your uke and not according to the placement shown on the plan!
- Wood Species
- Honduran Mahogany
- Shipping Restrictions - Location
- No Restrictions
- Scale Length
- 14.75" or 374.7mm scale length
- Neck Attachment