FWSS110

Fretwire, stainless steel, 4 feet

$12.43

Stainless Steel. A large crown wire in both height and width.

Fretwire is sold in either 4 or 100-foot lengths. 4 feet is normally enough for one standard instrument if you're not wasteful, but please check your plans before ordering. For easier installation, fretwire is coiled with the tang toward the inside of the curve. 4-foot sections might be cut into halves for shipping purposes. All of the fretwire we carry will fit into a .023" slot, with the exception of the FW75 nickel/silver wire.

SAVE $$ - Quantity discounts

Purchase this quantity to... save this much:
3 $4.08
Purchase this quantity to...


In Stock

Product Description

More and more builders are using stainless steel fretwire because of its resistance to wear and its playability. More difficult to use due to its hardness, stainless fretwire is not for everyone. Our experience is that it is much harder on your tools. There are two schools of thought on how to combat this: 1) Buy less expensive tools, and go through more of them. Or 2) Buy expensive tools and they'll last longer.

Installation Tip: The juncture of the tang and the crown on fretwire is not a crisp 90º angle, instead it is slightly radiused (+/- 15º) We recommend slightly beveling the edges of the fingerboard slots with a needle file so that the fretwire seats properly. This beveling also makes it possible to pull out the fretwire, if necessary, without fear of tearing up wood. A drop or so of water in the fret slot helps lubricate for easier tang entry.

Fretwire Sizes and Slot Widths article

Details

Shipping Restrictions - Location
No Restrictions
Content
Stainless Steel
Fret Height
.131" or 3.3mm
Crown Height
.057" or 1.4mm
Crown Width
.110" or 2.7mm
Tang Width
.020" or .5mm
Stud Width
.036" or .9mm

Reviews

No customer reviews for the moment.

Write your review

Fretwire, stainless steel, 4 feet

Stainless Steel. A large crown wire in both height and width.

Fretwire is sold in either 4 or 100-foot lengths. 4 feet is normally enough for one standard instrument if you're not wasteful, but please check your plans before ordering. For easier installation, fretwire is coiled with the tang toward the inside of the curve. 4-foot sections might be cut into halves for shipping purposes. All of the fretwire we carry will fit into a .023" slot, with the exception of the FW75 nickel/silver wire.

Write your review

Recommended Products