FW7500

Fretwire, 18% nickel/silver, 100 feet

$89.49

Fretwire is sold in either 4 or 100 foot lengths. This is normally enough for one standard instrument if you're not wasteful, but please check your plans before ordering. For easier installation, fretwire is coiled with the tang toward the inside of the curve. 4 foot sections might be cut into halves for shipping purposes. All of the fretwire we carry will fit into a .023" slot, with the exception of the FW75 nickel/silver wire.

Quantity discounts

Quantity You Save
3 $29.52
Quantity


In Stock

Product Description

Installation Tip: The juncture of the tang and the crown on fretwire is not a crisp 90º angle, instead it is slightly radiused (+/- 15º) We recommend slightly beveling the edges of the fingerboard slots with a needle file so that the fretwire seats properly. This beveling also makes it possible to pull out the fretwire, if necessary, without fear of tearing up wood. A drop or so of water in the fret slot helps lubricate for easier tang entry.

Fretwire Sizes and Slot Widths article

Details

Shipping Restrictions - Location
No Restrictions
Content
Nickel/Silver
Fret Height
.129" or 3.2mm
Crown Height
.043" or 1mm
Crown Width
.098" or 2.4mm
Tang Width
.024" or .6mm
Stud Width
.048" or 1.2mm
Sold by Length
Approx. 100 feet

Recommended Products

Reviews

No customer reviews for the moment.

Write your review

Fretwire, 18% nickel/silver, 100 feet

Fretwire is sold in either 4 or 100 foot lengths. This is normally enough for one standard instrument if you're not wasteful, but please check your plans before ordering. For easier installation, fretwire is coiled with the tang toward the inside of the curve. 4 foot sections might be cut into halves for shipping purposes. All of the fretwire we carry will fit into a .023" slot, with the exception of the FW75 nickel/silver wire.

Write your review