O‘Brien Neck Joint Jig & Templates
Robbie O'Brien came up with this clever neck alignment/routing jig. The jig is simple but elegant as it helps you determine your correct neck angle and then gives you an easy way to transfer the angle to your neck. It enables you to rout the mortise and tenon accurately. Only a small amount of fitting is necessary after routing.
Message from a satisfied customer::
"I purchased your Dovetail jig. Had no trouble with the assembly and ran a few test dovetails, both neck and body, and was impressed and very happy with the results."
There are 4 products.

Router bit, carbide, 1/2" cut, 7 degree dovetail, 3/4"...
- On Sale

Router bit, carbide, 1/2" cut, 7 degree dovetail, 3/4"...
- On Sale

Router bit, carbide, 1/2" cut, straight cut, 1 1/4" LOC,...
- On Sale